Users Guide

X:X:X:X::X IPv6 address
Dell(conf-if-te-1/2)# ipv6 address 2002:1:2::3 ?
<0-128> Prefix length in bits
Dell(conf-if-te-1/2)# ipv6 address 2002:1:2::3 /96 ?
<cr>
Dell(conf-if-te-1/2)#
ipv6 address 2002:1:2::3 /96
Dell(conf-if-te-1/2)# show config
!
interface TenGigabitEthernet 1/2
no ip address
ipv6 address 2002:1:2::3 /96
no shutdown
ipv6 address eui64
Configure IPv6 EUI64 address configuration on the interface.
Syntax
ipv6 address {ipv6-address prefix-length} eui64
To disable IPv6 EUI64 address autoconfiguration, use the no ipv6 address {ipv6-
address prefix-length} eui64 command.
Parameters
ipv6-address
prefix-length
Enter the IPv6 prefix in the x:x:x:x::x format then the prefix
length in the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.2) Introduced.
IPv6 Basics 1066