Users Guide

Default Disabled
Command Modes INTERFACE (management interface only)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.1.(0.0) Updated Usage Information section.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
Usage Infomation
• SAA can configure up to two addresses. If any preferred prefix or valid timers time
out, the corresponding address are deprecated or removed. If an address is
removed due to a time-out, an address from the current unused prefix is used to
create a new address. If there are no remaining prefixes, the software waits to
receive a new prefix from the RA.
• If auto-configuration is enabled, all IPv6 addresses on that management interface
are auto-configured. Manual and auto-configurations are not supported on a
single management interface.
• Removing auto-configuration removes all auto-configured IPv6 addresses and
the link-local IPv6 address from that management interface.
• IPv6 addresses on a single management interface cannot be members of the
same subnet.
• IPv6 secondary addresses on management interfaces across a platform must be
members of the same subnet.
• IPv6 secondary addresses on management interfaces should not match the virtual
IP address and should not be in the same subnet as the virtual IP.
ipv6 address
Configure an IPv6 address to an interface.
Syntax
ipv6 address {ipv6-address prefix-length}
IPv6 Basics 1064