Users Guide

warning-
threshold
Warning threshold value is expressed as a percentage of the limit
value. When the number of IPv6 routes reaches the specified
percentage of the limit, a warning message is generated. Valid
range is 1 to 100. When warn-threshold is used, once the limit is
reached, additional routes will not be allowed into the RTM
( route table manager ) itself.
warning-only When the warning-only option is used, a syslog message will be
thrown when maximum number of dynamic IPv6 routes reaches
the limit. Additional dynamic IPv6 routes will still be allowed.
Defaults No limit is set on the maximum number of dynamic IPv6 routes for a VRF.
Command Modes
CONFIGURATION-VRF
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000-ON,
and Z9500.
Usage Information
If the maximum IPv6 route limit is not specified for a VRF (valid range is from 1 to
8000), then it has unlimited space that extends to the maximum number of entries
allowed for the system. This command is not applicable to the default and
management VRFs.
ipv6 address autoconfig
Configure IPv6 address auto-configuration for the management interface.
Syntax
ipv6 address autoconfig
To disable the address autoconfig operation on the management interface, use the no
ipv6 address autoconfig command.
IPv6 Basics 1063