Users Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.4.2.1 Introduced on the S-Series.
8.2.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series. Increased the name string to accept
up to 140 characters. Prior to version 7.8.1.0, names are up to 16
characters long.
7.4.1.0 Introduced on the E-Series.
Usage Information The number of entries allowed per ACL is hardware-dependent. For detailed
specification on entries allowed per ACL, refer to your line card documentation. You
can create an IPv6 ACL for control-plane traffic policing for OSPFv3, in addition to the
CoPP support for VRRP, BGP, and ICMP.
cam-acl-egress
Allocate space for IPv6 egress ACLs.
Syntax
cam-acl-egress {default | l2acl 1-4 ipv4acl 1-4 ipv6acl 0-4}
Parameters
default Use the default CAM profile settings, and set the CAM as follows:
• L2 ACL(l2acl): 1
• L3 ACL (ipv4acl: 1
• IPv6 L3 ACL (ipv6acl): 2
l2acl 1-4 ipv4acl
1- 4 ipv6acl 0-4
Allocate space to support IPv6 ACLs. Enter all of the profiles and
a range. Enter the CAM profile name then the amount to be
allotted. The total space allocated must equal 4. The ipv6acl
range must be a factor of 2.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
IPv6 Access Control Lists (IPv6 ACLs) 1055