Users Guide

Commands

• cam-acl — configure CAM profiles to support IPv6 ACLs.

permit icmp

To allow all or specific internet control message protocol (ICMP) messages, configure a filter.

Syntax

permit icmp {source address mask | any | host ipv6-address}

{destination address | any | host ipv6-address} [message-type]

[count [byte]] | [log] [monitor]

To remove this filter, you have two choices:

• Use the no seq sequence-number command if you know the filter’s sequence

number.

• Use the no permit icmp {source address mask | any | host ipv6-

address} {destination address | any | host ipv6-address}

command.

Parameters

Defaults Not configured.

Command Modes ACCESS-LIST

Command History

This guide is platform-specific. For command information about other platforms, see

the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.7.0 Introduced on the S4810.

8.4.2.1 Introduced on the S-Series.

8.2.1.0 Introduced on the E-Series.

IPv6 Access Control Lists (IPv6 ACLs) 1051