Users Guide

NOTE: These options are supported only on the E-Series.
Parameters
all (OPTIONAL) Enter the keyword all to view statistics from all
processors. If you do not enter a keyword, you also view all
statistics from all processors.
cp (OPTIONAL) Enter the keyword cp to view only statistics from
the Control Processor.
rp1 (OPTIONAL) Enter the keyword rp1 to view only the statistics
from Route Processor 1.
rp2 (OPTIONAL) Enter the keyword rp2 to view only the statistics
from Route Processor 2.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 F10 Monitoring MIB available for the ip traffic statistics
command.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information The following describes the show ip traffic summary shown in the following
example.
IPv4 Routing 1041