Users Guide

• For a tunnel interface, enter the keyword tunnel then the
tunnel interface number. The range is from 1 to 16383.
brief (OPTIONAL) Enter the keyword brief to view a brief summary
of the interfaces and whether an IP address is assigned.
configured (OPTIONAL) Enter the keyword configured to display the
physical interfaces with non-default configurations only.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.1.1.2 Supported on the E-Series E600i.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information The following describes the show ip interface command shown in the following
example.
Lines Description
TenGigabitEthern
et 1/1...
Displays the interface’s type, physical and line protocol status.
IPv4 Routing 1027