Users Guide

The show ip flow command does not compute the egress port information when
load-balance mac hashing is also configured due to insufficient information (the
egress MAC is not available).
S-Series produces the following error message: %Error: Unable to read IP
route table.
Example
Dell# show ip flow interface te 2/42 20.1.1.1 100.1.1.2 protocol
tcp
Flow: 20.1.1.1 100.1.1.2 6
Ingress interface: Te 2/42
Egress Interface: Te 2/43
Dell#
show ip interface
View IP-related information on all interfaces.
Syntax
show ip interface [interface | brief] [configured]
Parameters
interface (OPTIONAL)
Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For the Management interface on the stack-unit, enter the
keyword ManagementEthernet then the slot/port
information.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a Null interface, enter the keyword null then the Null
interface number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
• For a stack-unit interface, enter the keyword stack-unit
then the stack unit number.
IPv4 Routing 1026