Users Guide

source-ip address Enter the keywords source-ip then the IP source address in IP
address format.
destination-ip
address
Enter the keywords destination-ip then the IP destination
address in IP address format.
protocol number
[tcp | udp]
Enter the keyword protocol then one of the protocol type
keywords: tcp, udp, or protocol number The protocol
number range is from 0 to 255. .
src-port number Enter the keywords src-port then the source port number.
destination-port
number
Enter the keywords destination-port then the destination port
number.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.1.1.0 Introduced on the E-Series.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information
This command provides egress port information for a given IP flow. This information is
useful in identifying which interface the packet follows in the case of Port-channel and
Equal Cost Multi Paths. Use this command for routed packed only. For switched
packets, use the show port-channel-flow command.
IPv4 Routing 1025