Users Guide

Related
Commands
• traceroute — view the DNS resolution.
• ip host — configure a host.
show ip cam stack-unit
Display CAM entries for a port-pipe of a stack-unit on a S-Series or Z-Series switch.
Syntax
show ip cam stack-unit {stack-unit-number} [port-set {pipe-number}
| vrf vrf-name {ip-address mask [longer-prefixes [ecmp-group
detail]]}| ecmp-group {detail | member-info [detail [group-index
index-number]]}| summary]
Parameters
stack-unit-
number
Enter the stack-unit ID. The unit ID range is from 1 to 6.
port-set pipe-
number
Enter the keyword port-set then the number of the stack
unit’s port-pipe. The unit ID range is from 0 to 0.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to
display CAM entries corresponding to that VRF.
network mask
[longer-prefixes
[ecmp-group
detail]]
(OPTIONAL) Enter the IP address and mask of a route to CAM
entries for that route only. You can enter one of the following
keywords to filter results.
• Enter the keyword longer-prefixes to view routes with
a common prefix.
• Enter the keyword ecmp-group detail to view the
ECMP group index.
ecmp-group
{detail | member-
info [detail
[group-index
index-number]]}
(OPTIONAL) Enter the keyword ecmp-group then one of the
following keywords to filter results.
• Enter the keyword detail to view the ECMP group index.
• Enter the keyword member-info to view the member
information for the ECMP group.
• Enter the keyword member-info detail to view detailed
ECMP membership and n-hop information.
• Enter the keyword group-index then the index number
to show ECMP membership per group. The range is from 0
to 1022.
summary (OPTIONAL) Enter the keyword summary to view a table listing
route prefixes and the total number routes which can be
entered in to CAM.
IPv4 Routing 1020