Users Guide

Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Added support for VRF and added usage information for the
clear arp-cache command.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4094 VLANs on the E-Series (the prior limit
was 2094).
8.1.1.0 Introduced on the E-Series.
7.9.1.0 Introduced VRF on the E-Series.
7.8.1.0 Augmented to display local ARP entries learned from private
VLANs (PVLANs).
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information The following example shows two VLANs that are associated with a private VLAN
(PVLAN) (refer to Private VLAN (PVLAN)).
If you have entered the clear arp-cache command to remove a large number of
ARP entries and the command is still being processed in the background, an error
message display if you attempt to enter the show arp command:
Clear arp in-progress. Please try after sometime!
The following describes the show arp command shown in the following example.
Description
Protocol Displays the protocol type.
Address Displays the IP address of the ARP entry.
Age(min) Displays the age (in minutes) of the ARP entry.
IPv4 Routing 1015