Users Guide

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for forty gigabit, vlan, and tengigabit ethernet
interfaces. Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000 and added support for IPv6.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information When a static route (or a protocol route) overlaps with Management static route, the
static route (or a protocol route) is preferred over the Management Static route. Also,
Management static routes and the Management Connected prefix are not reflected in
the hardware routing tables. Separate routing tables are maintained for IPv4 and IPv6
management routes. This command manages both tables.
Related
Commands
• interface ManagementEthernet — configure the Management port on the system
(either the Primary or Standby RPM).
• speed (Management interface) — set the speed for the Management interface.
show arp
Display the ARP table.
Syntax
show arp [vrf vrf-name] [interface interface | ip ip-address
[mask] | macaddress mac-address [mac-address mask]] [retries]
[static | dynamic] [inspection {database | statistics][summary]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of the
VRF.
IPv4 Routing 1013