Users Guide

management route
Configure a static route that points to the Management interface or a forwarding router.
Syntax
management route {ip-address mask | ipv6-address 1.1.1.1prefix-
length} {forwarding-router-address | managementethernet |
fortyGigE | vlan | tengigabitethernet}
To remove a static route, use the no management route command.
Parameters
ip-address mask Enter an IP address (dotted decimal format) and mask (/prefix
format) of the destination subnet.
ipv6-address
prefix-length
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix
format) of the destination subnet. Enter the IPv6 address in the
x:x:x:x::x format followed by the prefix length in the /x format.
The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
forwarding-
router-address
Enter an IP address (dotted decimal format) or an IPv6 address
(x:x:x:x::x format) of a forwarding router.
managementethe
rnet
Enter the keyword managementethernet for the Management
interface on the Primary RPM.
fortyGigE Enter the keyword fortyGigE to specify a forty Gigbit Ethernet
interface.
vlan Enter the keyword vlan to specify a vlan interface.
tengigabitethernet Enter the keyword tengigabitethernet to specify a ten Gigabit
Ethernete interface.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
IPv4 Routing 1012