Users Guide

tag tag-value (OPTIONAL) Enter the keyword tag then a number to assign to
the route. The range is from 1 to 4294967295.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF. Use
this VRF option after the next hop to specify which VRF the next
hop belongs to. This setting is used in route leaking cases. See
“R”oute Leaking VRFs” in the Virtual Routing and Forwarding
(VRF) section of the Configuration guide.
weight weight-
value
Enter the keyword weight followed by a weight value. The
range is from 0 to 255.
NOTE: Weight for a static route can be added only for
the destination address and not for the route pointing to
destination a interface.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2.(0.0) Added support for tunnel interface type.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4094 VLANs on the E-Series (the prior limit
was 2094).
8.1.1.0 Introduced on the E-Series.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
IPv4 Routing 1004