Users Guide
permit
To congure a lter that matches the lter criteria, select an IPv6 protocol number, ICMP, IPv6, TCP, or UDP.
Syntax
permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp}
To remove this lter, you have two choices:
• Use the no seq sequence-number command syntax if you know the lter’s sequence number
• Use the no permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp} command
Parameters
ip-protocol-number Enter an IPv6 protocol number. The range is from 0 to 255.
icmp Enter the keyword icmp to lter internet Control Message Protocol version 6.
ipv6 Enter the keyword ipv6 to lter any internet Protocol version 6.
tcp Enter the keyword tcp to lter the Transmission Control protocol.
udp Enter the keyword udp to lter the User Datagram Protocol.
Defaults Not congured.
Command Modes ACCESS-LIST
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
952 IPv6 Access Control Lists (IPv6 ACLs)