Users Guide
Version Description
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced for the E-Series.
Usage Information To avoid denial of service (DOS) attacks, keep the number of fragments allowed for re-assembly low.
ip max-routes
Enables you to congure the maximum number of protocol routes per VRF that are allowed for IPv4.
Syntax
ip max-routes [vrf vrf-name] max-number
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF for which you want to congure
maximum number of protocol routes that IPv4 allows.
max-number Enter the maximum number of protocol routes that a VRF RTM can hold. The range is
from 0 to 7500.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.4.(0.0) Introduced on the S4810 and S4820T.
Usage Information Use this command to specify the maximum number of protocol routes that the Route Table Manager can hold for a
specic VRF. This command does not apply to the management VRFs.
Related Commands
• show ip route — view the switch routing table.
• show ipv6 route — display the IPv6 routes.
ip mtu
Set the IP MTU (frame size) of the packet the RPM transmits for the line card interface. If the packet must be fragmented, Dell EMC
Networking OS sets the size of the fragmented packets to the size specied in this command.
Syntax
ip mtu value
IPv4 Routing 905