Users Guide

only have the shutdown, description, and name commands congured. The Port Channel’s conguration is
applied to the interfaces within the Port Channel.
A Port Channel can contain any physical interface. Based on the rst interface congured in the Port Channel and
enabled, Dell EMC Networking OS determines the common speed. For more information, refer to channel-member.
If the line card is in a Jumbo mode chassis, you can also congure the mtu and ip mtu commands. The Link MTU
and IP MTU values congured on the channel members must be greater than the Link MTU and IP MTU values
congured on the Port Channel interface.
NOTE: In a Jumbo-enabled system, all members of a Port Channel must be congured with the same link
MTU values and the same IP MTU values.
Example
DellEMC(conf)# int port-channel 2
DellEMC(conf-if-po-2)#
Related Commands
• channel-member — add a physical interface to the LAG.
• interface — congure a physical interface.
• interface loopback — congure a Loopback interface.
• interface null — congure a null interface.
• interface vlan — congure a VLAN.
• shutdown — disable/enable the port channel.
minimum-links
Congure the minimum number of links in a LAG (Port Channel) that must be in “oper up” status for the LAG to be also in “oper up” status.
Syntax
minimum-links number
Parameters
number Enter the number of links in a LAG that must be in “oper up” status. The range is from 1 to
16. The default is 1.
Defaults 1
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
850 Interfaces