Users Guide

interface port-channel
Create a Port Channel interface, which is a link aggregation group (LAG) containing 16 physical interfaces on the S-Series.
Syntax
interface port-channel channel-number
To delete a Port Channel, use the no interface port-channel channel-number command.
Parameters
channel-number For a Port Channel interface, enter the keywords port-channel then a number. The
range is from 1 to 128.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Increased the number of port channels to 4096.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on S4810.
8.3.11.1 Introduced on Z9000.
8.1.1.0 Introduced on E-Series.
7.6.1.0 Introduced on S-Series.
7.5.1.0 Introduced on C-Series.
pre-Version 6.2.1.0 Introduced on E-Series.
Usage Information
Port Channel interfaces are logical interfaces and can be either in Layer 2 mode (by using the switchport
command) or Layer 3 mode (by conguring an IP address). You can add a Port Channel in Layer 2 mode to a
VLAN.
The shutdown, description, and name commands are the only commands that you can congure on an
interface while it is a member of a Port Channel. To add a physical interface to a Port Channel, the interface can
Interfaces 849