Users Guide

Version Description
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Example
DellEMC(conf)# interface range tengigabitethernet 1/1 - 2
DellEMC(conf-if-range-gi-1/1-2)# show config
!
interface TenGigabitEthernet 1/1
no ip address
switchport
no shutdown
!
interface TenGigabitEthernet 1/2
no ip address
switchport
no shutdown
DellEMC(conf-if-range-gi-1/1-2)#
show interfaces
Display information on a specic physical interface or virtual interface.
Syntax
show interfaces interface-type[—range]
Parameters
interface Enter one of the following keywords and the interface information:
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For stack-units, enter the keywords stack-unit then the slot/port information.
•
For a Null interface, enter the keyword null then the Null interface number.
• For a port channel interface, enter the keywords port-channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel then the tunnel ID. The range is
from 1 to 16383.
NOTE: This command also enables you to view information corresponding to a
range of ports. However, for Open Networking (ON) platforms the notation for
specifying port range in the command is dierent from how you specify in non-
ON platforms.
-range (Optional) Enter the range of interfaces for which you want to view the information. The
format is interface-type slot/port/[subport]-slot/port/[subport]
Command Modes
• EXEC
• EXEC Privilege
Interfaces 809