Users Guide

Version Description
9.11.0.0 Introduced on all Dell EMC Networking OS platforms.
Usage Information
The output of the show interfaces command displays the congured rate interval, along with the collected
trac data.
When rate-interval is not congured in the global conguration mode or interface mode, the default value of 299
seconds is applied.
When rate-interval is congured only in the global conguration mode and not in the interface mode, the global
rate-interval value is applied at the interface level also.
When rate-interval is congured at the interface level and not in the global conguration mode, the interface level
rate-interval value is applied for an interface.
When rate interval is congured in both global conguration mode as well as interface mode, then the rate-interval
value congured at interface level is applied as it takes precedence over the global value.
show cong
Display the interface conguration.
Syntax
show config
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Interfaces 807