Users Guide

• Hybrid — port accepts both tagged and untagged frames
The following describes the interface vlan command shown in the following example. This example shows
unconguration of the hybrid port using the no portmode hybrid command.
NOTE: Remove all other congurations on the port before you can remove the hybrid conguration from
the port.
Example
DellEMC(conf)# interface tengigabitethernet 1/1
DellEMC(conf-if-te-1/1)# portmode hybrid
DellEMC(conf-if-te-1/1)# interface vlan 10
DellEMC(conf-if-vl-10)# untagged tengigabitethernet 1/1
DellEMC(conf-if-vl-10)# interface vlan 20
DellEMC(conf-if-vl-20)# tagged tengigabitethernet 1/1
DellEMC(conf-if-vl-20)#
Example
DellEMC(conf-if-vl-20)# do show interfaces switchport
Name: TenGigabitEthernet 1/1
802.1QTagged: Hybrid
Vlan membership:
Vlan 10, Vlan 20
Native VlanId: 10
DellEMC(conf-if-vl-20)#
Example (Vlan)
DellEMC(conf-if-vl-20)# interface vlan 10
DellEMC(conf-if-vl-10)# no untagged tengigabitethernet 1/1
DellEMC(conf-if-vl-10)# interface vlan 20
DellEMC(conf-if-vl-20)# no tagged tengigabitethernet 1/1
DellEMC(conf-if-vl-20)# interface tengigabitethernet 1/1
DellEMC(conf-if-te-1/1)# no portmode hybrid
DellEMC(conf-if-vl-20)#
rate-interval
Congure the trac sampling interval on the selected interface.
Syntax
rate-interval seconds
Parameters
seconds Enter the number of seconds for which to collect trac data. The range is from 5 to 299
seconds.
NOTE: Because polling occurs every 15 seconds, the number of seconds
designated here rounds to the multiple of 15 seconds lower than the entered
value. For example, if 44 seconds is designated, it rounds to 30; 45 to 59
seconds rounds to 45.
Defaults 299 seconds
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
Interfaces 805