Users Guide

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.1.1.2 Introduced on the E-Series.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

pre-Version 6.1.1.0 Introduced on the E-Series.

Usage Information When you congure keepalive, the system sends a self-addressed packet out of the congured interface to

verify that the far end of a WAN link is up. When you congure no keepalive, the system does not send

keepalive packets and so the local end of a WAN link remains up even if the remote end is down.

negotiation auto

Enable auto-negotiation on an interface.

Syntax

negotiation auto

To disable auto-negotiation, use the no negotiation auto command.

Defaults Enabled.

Command Modes INTERFACE

Command History

This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC