Users Guide

Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.1.(0.0) Introduced on the S4810; added support for OpenFlow.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Usage Information
For more information about VLANs and the commands to congure them, see Virtual LAN (VLAN) Commands.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs and IP ACLs are supported. For more
information, see Access Control Lists (ACL).
The following features are not supported on VLANs associated with an OpenFlow instance:
• IPv4
• IPv6
• MTU
If OpenFlow VLANs are congured on the switch, spanning-tree protocols cannot be enabled simultaneously.
Example (Single
Range)
DellEMC(conf)# int vlan 3
DellEMC(conf-if-vl-3)#
Related Commands
• interface — congure a physical interface.
• interface loopback — congure a loopback interface.
• interface null — congure a null interface.
• interface port-channel — congure a port channel group.
• show vlan — display the current VLAN conguration on the switch.
• shutdown — disable/enable the VLAN.
• tagged — add a Layer 2 interface to a VLAN as a tagged interface.
• untagged — add a Layer 2 interface to a VLAN as an untagged interface.
intf-type cr4 autoneg
Set the interface type as CR4 with auto-negotiation enabled. To set the interface type as CR4 with autonegotiation disabled, use the no
intf-type cr4 autoneg command.
Syntax
intf-type cr4 autoneg
Defaults
Not congured
Interfaces 795