Users Guide

Related Commands
• interface — congure a physical interface.
• interface loopback — congure a Loopback interface.
• interface port-channel — congure a port channel.
• interface vlan — congure a VLAN.
• ip unreachables — enable generation of internet control message protocol (ICMP) unreachable messages.
interface range
This command permits conguration of a range of interfaces to which subsequent commands are applied (bulk conguration). Using the
interface range command, you can enter identical commands for a range of interface.
Syntax
interface range interface {slot/port[subport] | port} — {slot/port[subport] |
port}, interface {slot/port[/subport] | port} — {slot/port[/subport] |
port},...
Parameters
interface {slot/
port[subport] |
port} — {slot/
port[subport] |
port}, interface
{slot/port[subport]
| port} — {slot/
port[subport] |
port},...
Enter interface range and one of the interfaces and then the interface information.
Select the range of interfaces for bulk conguration. You can enter up to six comma-
separated ranges. Spaces are not required between the commas. The ranges can include
VLANs, port-channels, and physical interfaces.
•
For a port channel interface, enter the keywords port-channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a Tunnel interface, enter the keyword Tunnel then a number from 1 to 16383.
Defaults None
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Updated the error message when no ports are congured within the specied interface
range.
9.13(0.0) Introduced the Conguration Terminal Batch mode on C9010.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
Interfaces 789