Users Guide
Version Description
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage Information This command applies to any physical interface with speed set to 10/100.
NOTE: Starting with Dell EMC Networking OS version 7.8.1.0, when you use a copper SFP2 module with
catalog number GP-SFP2-1T in the S25P model of the S-Series, you can manually set its speed with the
speed command. When you set the speed to 10 Mbps or 100 Mbps, you can also execute the duplex
command.
Related Commands
• negotiation auto — enable or disables auto-negotiation on an interface.
disable stack-unit phy temp polling
Disable physical temperature polling for 10GBase-T optical ports.
Syntax
disable stack-unit unit-number port port-number phy temp polling
To enable physical temperature polling, use the enable stack-unit unit-number port port-number
phy temp polling command.
Parameters
stack-unit unit-
number
Enter the keyword stack-unit then the unit-numberfor which you want to disable
temperature polling. The range is from 1 to 6.
port port-number Enter the keyword port then the port-number for which you want to disable
temperature polling. The range is from 1 to 48.
Defaults Enabled
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced on the S4048–ON and S5048F-ON.
Usage Information This feature is applicable only for 10GBase-T optical ports.
NOTE: It is not supported for stacking ports.
Interfaces 777