Users Guide

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
DellEMC#clear dampening tegigabitethernet 1/10
Clear dampening counters on TeGi 1/10 [confirm] y
DellEMC#
Related Commands
• show interfaces dampening — display interface dampening information.
• dampening — congure dampening on an interface.
dampening
Congure dampening on an interface.
Syntax
dampening [[[[half-life] [reuse-threshold]] [suppress-threshold]] [max-
suppress-time]]
Parameters
half-life Enter the number of seconds after which the penalty is decreased. The penalty decreases
half after the half-life period expires. The range is from 1 to 30 seconds. The default is 5
seconds.
reuse-threshold Enter a number as the reuse threshold, the penalty value below which the interface state
is changed to “up”. The range is from 1 to 20000. The default is 750.
suppress-threshold Enter a number as the suppress threshold, the penalty value above which the interface
state is changed to “error disabled”. The range is from 1 to 20000. The default is 2500.
max-suppress-time Enter the maximum number for which a route can be suppressed. The default is four
times the half-life value. The range is from 1 to 86400. The default is 20 seconds.
Defaults Disabled.
Command Modes INTERFACE (conf-if-)
772 Interfaces