Users Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the S-Series in Interface VLAN mode only to enable the system to act as
an IGMP Proxy Querier.
7.5.1.0 Introduced on the C-Series in Interface VLAN mode only to enable the system to act as
an IGMP Proxy Querier.
E-Series legacy
command.
ip igmp ssm-map
To translate (*,G) memberships to (S,G) memberships, use a statically congured list.
Syntax
ip igmp [vrf vrf-name] ssm-map std-access-list source-address
Undo this conguration, that is, remove SSM map (S,G) states and replace them with (*,G) state, use the ip
igmp [vrf vrf-name] ssm-map std-access-list source-address command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to congure this
setting on that VRF.
NOTE: Applies to specic VRF if input is provided, else applies to Default VRF.
std-access-list Specify the standard IP access list that contains the mapping rules for multicast groups.
source-address Specify the multicast source address to which the groups are mapped.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
750 Internet Group Management Protocol (IGMP)