Users Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
Usage Information
Before enabling FIP snooping, assign the fcoeacl space using the cam-acl command. If not assigned, the
following error message is displayed:
DellEMC(conf)#feature fip-snooping
% Error: Cannot enable fip snooping. CAM Region not allocated for Fcoe.
DellEMC(conf)#cam-acl l2acl 2 ipv4acl 0 ipv6acl 0 ipv4qos 2 l2qos 0 l2pt 0
ipmacacl 0 vman-qos 0 fcoeacl 2 etsacl 1 iscsi 2
DellEMC(conf)#feature fip-snooping
p-snooping enable
Enable FIP snooping on all VLANs or on a specied VLAN.
Syntax
fip-snooping enable
To disable the FIP snooping feature on all or a specied VLAN, use the no fip-snooping enable command.
Defaults FIP snooping is disabled on all VLANs.
Command Modes
• CONFIGURATION
• VLAN INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the Z9500 and S6000-ON.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
694 FIP Snooping