Users Guide
Version Description
9.7(0.0) Introduced on the S4810, S4820T, S6000, S6000–ON, Z9000, and Z9500.
Usage Information
Use this command on the interfaces where the DHCP clients are connected to forward the packets from clients to
DHCP server and vice-versa.
Example
DellEMC(conf-if-te-1/1)# ipv6 helper-address
X:X:X:X::X IPv6 helper address
VRF VRF name.
Global Global address space
show ip dhcp snooping
Display the contents of the DHCP binding table or display the interfaces congured with IP Source Guard.
Syntax
show ip dhcp snooping [binding | source-address-validation [discard-counters
[interface interface]]]
Parameters
Parameters Description
binding
Display the binding table.
source-address-
validation
Display the interfaces congured with IP Source Guard.
discard-counters
(OPTIONAL) Display the number of dropped packets.
interface interface
(OPTIONAL) Species an interface to show the discard counters.
Enter any of the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port[/subport] information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a port channel interface, enter the keywords port-channel then a number.
Defaults None
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
664 Dynamic Host Conguration Protocol (DHCP)