Users Guide
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Version 9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage Information
Use this command on the interfaces where the DHCP clients are connected to forward the packets from clients to
DHCP server and vice-versa.
Example
DellEMC(conf-if-te-1/12)# ip helper-address vrf jay 10.0.0.2
ipv6 helper-address
Congures the ipv6 DHCP helper addresses without VRF.
Syntax
[no] ipv6 helper-address ipv6-address
To delete the ipv6 helper address, use the [no] ipv6 helper-address ipv6-address command.
Parameters
ipv6-address Enter the keywordipv6–address through which the server address can be reached.
Default Disabled.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Dynamic Host Conguration Protocol (DHCP) 663