Users Guide

Debugging and Diagnostics
The basic debugging and diagnostic commands are supported by the Dell EMC Networking OS.
Topics:
• Diagnostics and Monitoring Commands
• Oine Diagnostic Commands
• Hardware Commands
Diagnostics and Monitoring Commands
The following section describes the diagnostics and monitoring commands.
For similar commands, refer to the Control and Monitoring chapter.
logging coredump stack-unit
Enable coredump on a stack.
Syntax
logging coredump stack-unit {stack-unit-number | all}
Parameters
stack-unit stack-
unit-number
Enter the stack-unit id to enable coredump in a particular stack-unit.
all Enable coredump on all stack-unit.
Defaults Enabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100-ON and the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
13
Debugging and Diagnostics 599