Users Guide

Enables priority ow control or enhance transmission selection on interface.
Related Commands
• dcb <ets | pfc> enable — enable priority ow control or enhanced transmission selection on interface.
description
Enter a text description of the DCB policy (PFC input or ETS output).
Syntax
description text
To remove the text description, use the no description command.
Parameters
text Enter the description of the output policy. The maximum is 32 characters.
Defaults None
Command Modes
• DCB INPUT POLICY
• DCB OUTPUT POLICY
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
priority-list
Congure the 802.1p priorities for the trac on which you want to apply an ETS output policy.
Syntax
priority-list value
To remove the priority list, use the no priority-list command.
Parameters
value Enter the priority list value. Separate priority values with a comma; specify a priority range
with a dash; for example, priority-list 3,5-7. The range is from 0 to 7.
Defaults None
Command Modes PRIORITY-GROUP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Data Center Bridging (DCB) 563