Users Guide

Parameters
stack-unit Enter the stack unit.
port-number Enter the port number.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Example (Summary)
Dell(conf)# show stack-unit all stack-ports all pfc details
stack unit 1 stack-port all
Admin mode is On
Admin is enabled, Priority list is 4-5
Local is enabled, Priority list is 4-5
Link Delay 45556 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
stack unit 2 stack-port all
Admin mode is On
Admin is enabled, Priority list is 4-5
Local is enabled, Priority list is 4-5
Link Delay 45556 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
Dell#
ETS Commands
The following ETS commands are supported on the Dell EMC Networking OS.
NOTE
: Before conguring ETS, assign the etsacl space. using the cam-acl l2acl 2 ipv4acl 0 ipv6acl 0 ipv4qos 2
l2qos 0 l2pt 0 ipmacacl 0 vman-qos 0 fcoeacl 2 etsacl 1 iscsi 2 command.
bandwidth-percentage
Congure the bandwidth percentage allocated to priority trac in port queues.
Syntax
bandwidth-percentage percentage
To remove the congured bandwidth percentage, use the no bandwidth-percentage command.
Parameters
percentage (Optional) Enter the bandwidth percentage. The percentage range is from 1 to 100% in
units of 1%.
Defaults none
Command Modes QOS-POLICY-OUT-ETS
560 Data Center Bridging (DCB)