Users Guide

Prompt Interface Type
DellEMC(conf-
if)#
INTERFACE mode
DellEMC(conf-
if-te-1/1)#
Ten-Gigabit Ethernet interface then slot/port information
DellEMC(conf-
if-fo-1/1)#
Forty-Gigabit Ethernet interface then slot/port information
DellEMC(conf-
if-lo-0)#
Loopback interface number
DellEMC(conf-
if-nu-0)#
Null Interface then zero
DellEMC(conf-
if-po-0)#
Port-channel interface number The range is from 1 to 128.
DellEMC(conf-
if-vl-0)#
VLAN Interface then VLAN number (range 1–4094)
DellEMC(conf-
if-ma-1/1)#
Management Ethernet interface then slot/port information
DellEMC(conf-
if-tu-0)#
Tunnel interface then tunnel ID.
DellEMC(conf-
if-range)#
Designated interface range (used for bulk conguration).
IP ACCESS LIST Mode
To enter IP ACCESS LIST mode and congure either standard or extended access control lists (ACLs), use the ip access-list
standard
command or the ip access-list extended command.
To enter IP ACCESS LIST mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter either the ip access-list standard command or the ip access-list extended command. Include a name for
the ACL. The prompt changes to include
conf-std-nacl or conf-ext-nacl.
You can return to CONFIGURATION mode by using the exit command.
ISIS ADDRESS-FAMILY Mode
To enable or congure IPv6 for ISIS, use ISIS ADDRESS-FAMILY mode. For more information, see Intermediate System to Intermediate
System (IS-IS).
To enter ISIS ADDRESS-FAMILY mode:
1 Verify that you are logged in to ROUTER ISIS mode.
2 Enter the address-family ipv6 unicast command. The prompt changes to include conf-router_isis-af_ipv6.
CLI Basics
55