Users Guide
• mac access-list extended — creates an extended MAC ACL.
• qos-policy-input — creates a QoS input policy map.
• class-map — creates a QoS class map.
• policy-map-input — creates an input policy map.
ip unknown-unicast
Enable IPv4 catch-all route.
Syntax
ip unknown-unicast [vrf vrf-name]
To remove the IPv4 catch-all route (0.0.0.0/0) from the LPM route forwarding table in hardware which gets added
as a default conguration after the initialization of FIB Agent module, use the no ip unknown-unicast
command.
Defaults None
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to enable catch-all
routes corresponding to that VRF.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S–Series.
Usage Information Use this command to add the IPv4 catch-all route (0.0.0.0/0) in the LPM route forwarding table if it was deleted
using the no ip unknown-unicast command previously. This will be the default conguration after reload.
544 Control Plane Policing (CoPP)