Users Guide

NOTE: When you recongure CAM allocation, use the nlbclusteracl
number command to change the number of NLB ARP entries. The range is from
0 to 2.
The default value is 0. At the default value of 0, eight NLB ARP entries
are available for use. This platform supports up to 512 CAM entries. Select 1 to
congure 256 entries. Select 2 to congure 512 entries. Even though you can
perform CAM carving to allocate the maximum number of NLB entries, Dell
EMC Networking recommends that you use a maximum of 64 NLB ARP entries.
vman-qos Enter the keyword vman-qos and then the number of FP blocks for VMAN QoS. The
range is from 0 to 6.
vman-dual-qos
number
Enter the keyword vman-dual-qos and then the number of FP blocks for VMAN dual
QoS. The range is from 0 to 4.
Ipv4pbr number Enter the keyword ipv4pbr and then the number of FP blocks for ipv4pbr ACL. The
range is from 0 to 8.
Openow number Enter the keyword openflow and then the number of FP blocks for open ow (multiples
of 4). The range is from 0 to 8.
fcoeacl number Enter the keyword fcoeacl and then the number of FP blocks for FCOE ACL. The
range is from 0 to 6.
Iscsioptacl number Enter the keyword iscsioptacl and then the number of FP blocks for iSCSI
optimization ACL. The range is from 0 to 2.
ipv4udfmirracl
Enter the keyword ipv4udfmirracl and then the number of FP blocks for IPv4 UDF
mirror ACL. The range is from 0 to 8.
ipv4mirracl
Enter the ipv4mirracl keyword and then the number of FP blocks for IPv4 mirror
ACL. The range is from 0 to 8. You cannot use the ipv4mirracl and
ipv4udfmirracl commands at the same time.
ipv6mirracl
Enter the ipv6mirracl keyword and then the number of FP blocks for IPv6 mirror
ACL. The range is from 0 to 4, in multiples of 2.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Added the keyword ipv6mirracl on the S6000 and S6000–ON. Introduced the
feature ipv6acloptimized command to make the IPv6 ACL CAM region double-
wide on the S5048F–ON, S6100–ON, and Z9100–ON.
9.12(1.0) Introduced on the S5048F–ON.
9.12(0.0) Added the keyword ipv4mirracl.
9.11(0.0) Added the keyword ipv4udfmirracl.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
530 Content Addressable Memory (CAM)