Users Guide

Version Description
8.3.8.0 Introduced the limit keyword on the S4810.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
After you congure a peer group as passive, assign it a subnet using the neighbor soft-reconfiguration
inbound command.
For passive eBGP limits, the Remote AS must be dierent from the AS for this neighbor.
Related Commands
• neighbor soft-reconguration inbound — assign a subnet to a dynamically congured BGP neighbor.
• neighbor remote-as — assign an indirectly connected AS to a neighbor or peer group.
neighbor remote-as
Create and specify the remote peer to the BGP neighbor.
Syntax
neighbor {ip-address | peer-group-name} remote-as number
To delete a remote AS entry, use the no neighbor {ip-address | peer-group-name} remote-as
number command.
Parameters
ip-address Enter the IP address of the neighbor to enter the remote AS in its routing table.
peer-group-name Enter the name of the peer group to enter the remote AS into routing tables of all routers
within the peer group.
number Enter a number of the AS. The range is from 0 to 65535 (2 byte) or from 1 to
4294967295 (4 byte).
Defaults Not congured.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Border Gateway Protocol 453