Users Guide

ipv6 unicast Enter the keyword ipv6 followed by the keyword unicast to enable BGPv6 mode.
Defaults Not congured.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for IPv6 VRF.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
6.5.1.0 Introduced
aggregate-address
To minimize the number of entries in the routing table, summarize a range of prexes.
Syntax
aggregate-address ip-address mask [advertise-map map-name] [as-set] [attribute-
map map-name] [summary-only] [suppress-map map-name]
Parameters
ip-address mask Enter the IP address and mask of the route to be the aggregate address. Enter the IP
address in dotted decimal format (A.B.C.D) and mask in /prex format (/x).
advertise-map
map-name
(OPTIONAL) Enter the keywords advertise-map then the name of a congured route
map to set lters for advertising an aggregate route.
as-set
(OPTIONAL) Enter the keyword as-set to generate path attribute information and
include it in the aggregate.
AS_SET includes AS_PATH and community information from the routes included in the
aggregated route.
Border Gateway Protocol 391