Users Guide

Version Description
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
Related Commands
ip access-list standard — congures a standard ACL.
ip access-list extended — creates an extended ACL.
feature udf-acl
Enable udf-acl feature on a switch.
Syntax
feature udf-acl
To disable the udf-acl feature, use the no feature udf-acl command.
Defaults Disabled
Command Modes CONFIGURATION
Example
Dell(conf)#feature udf-acl
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
key
Congure UDF data context for parsing the dierent header location oset and required bytes.
Syntax
key description udf-id id packetbase PacketBase offset bytes length bytes
To return to the default settings, use the no key description udf-id id packetbase PacketBase
offset bytes length bytes command.
Parameters
description Enter the key name for reference, up to 64 characters.
udf-id id Enter the keywords udf-id then the ID used in the actual UDF ACL group. The range is
from 1 to 12.
packetbase
PacketBase
Enter the keyword packetbase then the option to refer to start of packet oset. The
options are:
• innerL3Header — Oset is at inner L3 header.
• innerL4Header — Oset is at inner L4 header.
• outerL3Header — Oset is at outer L3 header.
• outerL4Header — Oset is at outer L4 header.
Access Control Lists (ACL) 305