Users Guide

Version Description
pre-Version 6.1.1.0 Introduced on the E-Series.
Example
DellEMC# show ip community-lists
ip community-list ABC
permit local-AS
deny no-advertise
permit no-export
DellEMC#
UDF ACL Commands
The following commands are available within each UDF ACL mode.
deny ip
Disassociate the UDF in IP access-list.
Syntax
deny ip {source mask | any | host ip-address} {destination mask | any | host
ip-address} udf-pkt-format name udf-qualifier-value name
To remove this lter, use the no seq sequence-number command.
Parameters
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prex format (/x) or A.B.C.D. The mask, when specied in
A.B.C.D format, may be either contiguous or noncontiguous.
any Enter the keyword any to specify that all routes are subject to the lter.
host ip-address Enter the keyword host then the IP address to specify a host IP address.
destination Enter the IP address of the network or host to which the packets are sent.
udf-pkt-format
name
Enter the keywords udf-pkt-format then the UDF ACL prole name.
udf-qualier-value
name
Enter the keywords udf-qualifier-value then the UDF qualier value prole name.
Command Modes
CONFIGURATION-STANDARD-ACCESS-LIST mode
CONFIGURATION-EXTENDED-ACCESS-LIST mode
Example
Dell(config-ext-nacl)#deny ip any any udf-pkt-format ipinip udf-qualifier-
value ipnip_val1
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
304 Access Control Lists (ACL)