Users Guide

Parameters
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prex format (/x) or A.B.C.D. The mask, when specied in
A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the lter.
host ip-address Enter the keyword host then the IP address to specify a host IP address.
bit Enter a ag or combination of bits:
• ack: acknowledgement eld
• fin: nish (no more data from the user)
• psh: push function
• rst: reset the connection
• syn: synchronize sequence numbers
• urg: urgent eld
ttl Enter the keyword ttl to permit a packet based on the time to live value. The range is
from 1 to 255.
operator Enter one of the following logical operand:
• eq(equal to) — matches packets that contain a ttl value that is equal to the specied
ttl value.
• neq(not equal to) — matches packets that contain a ttl value that is not equal to the
specied ttl value.
•
gt(greater than) — matches packets that contain a ttl value that is greater than the
specied ttl value.
• lt (less than) — matches packets that contain a ttl value that is less than the
specied ttl value.
• range(inclusive range of values) — matches packets that contain a ttl value that
falls between the specied range of ttl values.
dscp Enter the keyword dscp to permit a packet based on the DSCP value. The range is from
0 to 63.
operator (OPTIONAL) Enter one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two ports for the port parameter)
port port Enter the application layer port number. Enter two port numbers if you are using the
range logical operand. The range is from 0 to 65535.
The following list includes some common TCP port numbers:
• 23 = Telnet
• 20 and 21 = FTP
• 25 = SMTP
• 169 = SNMP
Access Control Lists (ACL) 239