Users Guide

State: Master, Priority: 101, Master: fe80::201:e8ff:fe7a:6bb9 (local)
Hold Down: 0 centisec, Preempt: TRUE, AdvInt: 100 centisec
Accept Mode: FALSE, Master AdvInt: 100 centisec
Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 64
Virtual MAC address:
00:00:5e:00:02:ff
Virtual IP address:
1::255 fe80::255
vrrp-ipv6-group
Assign an interface to a VRRP group.
Syntax
vrrp-ipv6-group vrid
Parameters
vrid Enter the virtual-router ID number of the VRRP group. The VRID range is from 1 to 255.
Defaults Not congured.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
8.4.2.1 The range of valid VRID values on the E-Series when VRF microcode is loaded in CAM
changed from 1 to 15.
8.4.1.0 Introduced on the E-Series, C-Series, and S-Series.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.2.0 Introduced on the E-Series.
Usage Information
The VRRP group only becomes active and sends VRRP packets when you congure a link-local virtual IP address.
When you delete the virtual address, the VRRP group stops sending VRRP packets.
• When you do not load the VRF microcode in the CAM, the VRID for a VRRP group is the same as the VRID
number congured with the vrrp-group or vrrp-ipv6-group commands.
•
When you load the VRF microcode in the CAM, the VRID for a VRRP group equals 16 times the vrrp-group
or vrrp-ipv6-group vrid number, plus the ip vrf vrf-id number. For example, if you load the VRF
Virtual Router Redundancy Protocol (VRRP) 2007