Users Guide

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port/subport[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a VLAN interface, enter the keyword vlan, and then the VLAN ID. The VLAN ID
range is from 1 to 4094.
priority-cost (OPTIONAL) Enter a number as the amount to subtract from the priority value. The range
is from 1 to 254. The default is 10.
Defaults priority cost = 10
Command Modes VRRP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
7.6.1.0 Introduced on the S-Series (S50 only).
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information
If you disable the interface, the cost value is subtracted from the priority value and forces a new MASTER election
if the priority value is lower than the priority value in the BACKUP virtual routers.
virtual-address
Congure up to 12 virtual router IP addresses in the VRRP group. To start sending VRRP packets, set at least one virtual IP address for the
VRRP group.
Syntax
virtual-address ip-address1 [... ip-address12]
To delete one or more virtual IP addresses, use the no virtual-address ip-address1 [... ip-
address12] command.
Parameters
ip-address1 Enter an IP address of the virtual router in dotted decimal format. The IP address must be
on the same subnet as the interface’s primary IP address.
Virtual Router Redundancy Protocol (VRRP) 1997