Users Guide

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
DellEMC(conf-if-vrid-4)# show config
vrrp-group 4
virtual-address 119.192.182.124
!
DellEMC(conf-if-vrid-4)#
show vrrp
View the VRRP groups that are active. If no VRRP groups are active, the Dell EMC Networking OS returns No Active VRRP group.
Syntax
show vrrp [vrrp-id][brief][interface type][ipv6][interface type][vrf vrf-name]
Parameters
vrrp-id (OPTIONAL) Enter the virtual router identier for the VRRP group to view only that
group. The range is from 1 to 255.
brief (OPTIONAL) Enter the keyword brief to view a table of information about the VRRP
groups.
interface type (OPTIONAL) Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
•
For a VLAN interface, enter the keyword vlan, and then the VLAN ID. The VLAN ID
range is from 1 to 4094.
ipv6 (OPTIONAL) Enter the keyword ipv6 to view only VRRP IPv6 groups.
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of the VRF to view active VRRP
groups corresponding to that VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
Virtual Router Redundancy Protocol (VRRP) 1993