Users Guide

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Added support for the peer-down-vlan option.
8.3.8.0 Introduced on the S4810.
Usage Information To congure the VLAN from where the VLT peer forwards packets received over the VLTi from an adjacent VLT
peer that is down, use the peer-down-vlan option. When a VLT peer with bare metal provisioning (BMP) is
booting up, it sends untagged DHCP discover packets to its peer over the VLTi. To ensure that the DHCP discover
packets are forwarded to the VLAN that has the DHCP server, use this conguration.
peer-routing
Enable Layer 3 (L3) VLT peer-routing. This command is applicable for both IPv6 and IPv4 interfaces.
Syntax
peer-routing
To disable L3 VLT peer-routing, use the no peer-routing command.
Defaults Disabled.
Command Modes VLT DOMAIN (conf-vlt-domain)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Added the support for IPV6 / IPV4.
1944 Virtual Link Trunking (VLT)