Users Guide

Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
Usage Information
To display syslog messages in a RFC 3164 or RFC 5424 format, use the log version command in conguration
mode. By default, the system log version is set to 0.
The following describes the two supported log messages formats:
• 0 – Displays syslog messages format as described in RFC 3164, The BSD syslog Protocol
•
1 – Displays SYSLOG message format as described in RFC 5424, The Syslog Protocol
Example
DellEMC(conf)#logging version ?
<0-1> Select syslog version (default = 0)
DellEMC(conf)#logging version 1
show logging
Display the logging settings and system messages logged to the internal buer of the switch.
Syntax
show logging [number | history [reverse][number] | reverse [number] | summary]
Parameters
number (OPTIONAL) Enter the number of messages displayed in the output. The range is from 1
to 65535.
history (OPTIONAL) Enter the keyword history to view only information in the Syslog history
table.
reverse (OPTIONAL) Enter the keyword reverse to view the Syslog messages in FIFO (rst in,
rst out) order.
summary (OPTIONAL) Enter the keyword summary to view a table showing the number of
messages per type and per slot. Slots *7* and *8* represent RPMs.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Simple Network Management Protocol (SNMP) and Syslog 1777