Users Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.4.1.0 Added support for IPv6.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information Multiple logging servers of both IPv4 and/or IPv6 can be congured.
Related Commands
• logging on — enables the logging asynchronously to logging buer, console, Syslog server, and terminal lines.
• logging trap — enables logging to the Syslog server based on severity.
logging buered
Enable logging and specify which messages are logged to an internal buer. By default, all messages are logged to the internal buer.
Syntax
logging buffered [level] [size]
To return to the default values, use the default logging buffered command.
To disable logging stored to an internal buer, use the no logging buffered command.
Parameters
level (OPTIONAL) Indicate a value from 0 to 7 or enter one of the following equivalent words:
emergencies, alerts, critical, errors, warnings, notifications,
informational, or debugging. The default is 7 or debugging.
size (OPTIONAL) Indicate the size, in bytes, of the logging buer. The number of messages
buered depends on the size of each message. The range is from 40960 to 524288. The
default is 40960 bytes.
Defaults level = 7; size = 40960 bytes
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
1764 Simple Network Management Protocol (SNMP) and Syslog