Users Guide
• linkdown
• linkup
• syslog-reachable
• syslog-unreachable
Defaults Not enabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced MAC address notication traps on all the Dell EMC Networking OS platforms.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the following two SNMP notication options: syslog-reachable and
syslog-unreachable.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
9.0.2.0 Introduced on the S6000.
9.1(0.0) Added support for copy-cong and ECMP traps.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.4.1.0 Added support for VRRP traps.
7.6.1.0 Added support for STP and xSTP traps. Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information
Dell EMC Networking OS supports up to 16 SNMP trap receivers.
If you do not congure this command, traps that controlled by this command are not sent. If you do not specify a
notification-type and notification-option, all traps are enabled.
Simple Network Management Protocol (SNMP) and Syslog 1741