Users Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on S-Series Stacking.
8.1.1.0 Introduced on the E-Series.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information This command changes the sampling rate for an interface. By default, the sampling rate of an interface is set to the
same value as the current global default sampling rate. If the value entered is not a correct power of 2, the
command generates an error message with the previous and next power-of-2 value. Select one of these two
number and re-enter the command.
Related Commands
• sow sample-rate (Global) — changes the sampling rate globally.
show sow
Display the current sFlow conguration.
Syntax
show sflow [interface]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port/subport[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For the Management interface on the, enter the keyword ManagementEthernet
then the slot/port information.
• For a port-channel interface, enter the keywords port-channel then the port-
channel ID.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
1728 sFlow