Users Guide

To disable protocol tunneling for a Layer 2 protocol, use the no protocol-tunnel command.
Parameters
rate-limit rate Enter the keyword rate-limit followed by a number for the rate-limit for tunneled
packets on the VMAN. The range is from 64 to 320.
stp Enter the keyword stp to enable protocol tunneling on a spanning tree, including STP,
MSTP, RSTP, and PVST.
Defaults none
Command Modes CONF-IF-VLAN
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.5.1.1 Added support for 802.1X, E-LMI, GMRP, GVRP, LLDP, LACP, MMRP, MVRP, and OAM
802.3ah protocol trac to the E-Series.
8.2.1.0 Introduced on the C-Series, E-Series, and E-Series.
7.4.1.0 Introduced
Example
DellEMC# conf
DellEMC(conf)#interface vlan 2
DellEMC(conf-if-vl-2)#vlan-stack compatible
DellEMC(conf-if-vl-2)#member Te 1/2-3
DellEMC(conf-if-vl-2)#protocol-tunnel stp
DellEMC(conf-if-vl-2)#protocol-tunnel enable
Related Command
• show protocol-tunnel — displays tunneling information for all VLANs.
protocol-tunnel destination-mac
Overwrite the BPDU destination MAC address with a specic value.
Syntax
protocol-tunnel destination-mac xstp address
Service Provider Bridging 1713